HOW TO GUIDE:

  • 1. Prepare the Nail: Ensure fingers are clean and free from grease, clean nail cuticle, roughen nail surface with nail filer and wipe clean with alcohol wipe.

    2. Attach the Press-on Nail: Scoop PVC nail glue out from jar using the press-on nail and press the nail onto your natural nail tip in a rolling motion, dragging it towards your nail cuticle. Make sure to align it carefully and hold the press-on nail firmly in place.

    3. Clean Excess Glue: Use the cuticle stick to remove any excess glue that might have oozed out around the edges of your nails. Ensure there's a decent amount of glue between the fingertip and your fingers to secure the press-on nails. You can still adjust the position of the nail at this time.

    4. Curing the Nails: Place your fingers under an LED nail light. Follow the instructions for the recommended curing time. Time will vary between lighter shades and darker shades (generally 2-4 minutes).

    5. To extend your wear, please avoid water or getting the nails wet for 2-3 hours after application.

    Removal:

    1. Remove the nail by lifting the edges of the press-on nail using the supplied cuticle stick. Gently and slowly lift the press-on nail and it should come right off.

    2. To reuse the press-on nail following PVC application, use pointy end of cuticle stick to lift the PVC glue off the back of the press-on nail. Use fingers to rip the glue off if needed.

    For a more detailed guide, please watch the video and tips below.

  • 1. Prepare the Nail: Ensure fingers are clean and free from grease, clean nail cuticle, roughen nail surface with nail filer and wipe clean with alcohol wipe.

    2. Apply Adhesive Tabs: Match the size of your own nails to the adhesive tape size. Peel off tape and cover entire natural nail surface with it, use your finger to rub and press down the adhesive tabs to warm up the glue, remember to peel off second layer of film on adhesive tabs in order to be able to stick onto press-on nails.

    3. Attach Press-on Nails: Place at 45-degree angle, press firmly and smooth out bubbles.

    4. Clean Up: Wipe with alcohol for a neat finish.

    Removal:

    1. Soak nails in warm water for a few minutes.

    2. Remove the nail by lifting the edges of the press-on nail using the supplied cuticle stick. Gently and slowly lift the press-on nail and it should come right off.

    3. To reuse the press-on nail following adhesive tabs application, you should be able to just take the adhesive tabs off the back of the press-on nails without leaving any residue.

    For a more detailed guide, please watch the video and tips below.

  • 1. Choose the Right Size: Select press-on nails that match your natural nail sizes.

    2. Prepare Nails and Glue: Ensure fingers are clean and free from grease, clean nail cuticle, roughen nail surface with nail filer and wipe clean with alcohol wipe. Arrange nails in order and have nail glue ready.

    3. Apply Glue: Apply a small drop of glue onto the center of each press-on nail, avoiding the edges.

    4. Apply to Natural Nails: Align and press the nails onto your natural nails.

    5. Secure Press-On Nails: Press and hold each nail from the root to the edge for 10 seconds for a strong bond.

    6. Clean Up Excess Glue: Use alcohol wipes to remove any spilled glue around the edges.

    Removal:

    Soak in warm water for 5 minutes, lift edges with cuticle stick.

    For a more detailed guide, please watch the video and tips below.

TIPS๏ผš

  • After wiping your nails with the alcohol pad, avoid touching them with your fingertips. Touching them could reintroduce oils that the alcohol wipe effectively removed.

  • Extend the life of your press-ons by avoiding water contact 1-2 hours post-application.

  • Choose the right sizeโ€”neither too large nor too smallโ€”to prevent water from seeping underneath, which may cause discoloration or premature lifting due to interaction with the glue.

  • Trim and shape (OPTIONAL): Trim or file the press on nails to your desired length or shape, you can choose to do this before or after application.

  • If gaps appear between natural nail and press ons due to the difference in nail shape curve, you have options: add a tiny drop of glue between the press-on and your natural nail (applicable too all application methods) or pre-heat the press-on with a blow dryer for about 10 seconds and gently hold the press-on to your natural nail, allowing it to conform to the desired shape curve.

  • Although we include glue for your convenience, we advise against its use as it may potentially harm your natural nails. We prioritize the health and well-being of your nails and suggest exploring PVC glue or adhesive tape for a safer and gentler application.